Capitol Equipment
NewEagleFintecCemcoApplicationsContactUsed
<< Back to Used

1998 Eagle 500-05CV Portable Crusher

1998 EAGLE 500-05 CV PORTABLE CRUSHER

 

Receiving Hopper: heavy-duty, steel reinforcement of side plates, 6’2” x 16’2” top opening;

 

Vibrating Grizzly Feeder: 32” x 14’ lg., includes 60” tapered step grizzly of nominal 1-1/2” openings, 20 HP, 1200 RPM, TEFC, electric motor drive, mounted as integral part with hopper on common base;

 

Horizontal Shaft Impactor: Eagle UltraMax 05 primary/secondary, weight – 19,500 lbs., 33” x 32” feed opening, exclusive fixed bar solid steel sculptured rotor, cast primary curtain, fabricated secondary curtain with wear resistant replaceable liners, hydraulic shim adjustment on secondary curtain crusher housing split with gas powered hydraulic opening for access to rotor, curtains and replaceable liners;

 

Fines Bypass Chute: for diverting material to the under-crusher gathering hopper;

 

Under-Crusher Gathering Hopper: heavy-duty steel plate complete with full length rubber flashing and replaceable liner;                           

 

Discharge Conveyor: 30” x 31’6” lg., for conveying the crusher discharge material to the front of plant, 20º troughing idlers, high impact urethane/rubber slider bed under impactor discharge area, return rollers, lagged head pulley, wing tail pulley, telescoping belt take-ups, 10 HP electric motor drive;

 

Platforms and Railings: structural steel frame with expanded metal floor, platforms and railings located at the crusher, diesel, and hopper for operation;

 

Main Trailer Frame: 18” wide flange beam side rails, air-ride tri-axle suspension with 71” track axles, twelve 11:00 x 22.5 12-ply tires, air controlled brakes with emergency and service gladhands, fifth wheel plate and kingpin, prewired running lights with stop, directional and 3 light marker bar;

 

Hydraulic Lift/Leveling: set of four “stiff-leg” hydraulic cylinders controlled by gasoline-powered hydraulic unit complete with in-line load controls on each cylinder and directional control valves;

 

Drive Guards: formed sheet metal with wire mesh, complete with hinge type doors for easy access to pulleys and belts;

 

Central Control Panel: NEMA 4 type box, plant mounted complete with circuit breaker, transformer, motor starters and fuses, emergency stop push buttons, two extra 15 HP starters and fuses with quick disconnect plugs for radial stackers.  One dual 110 volt plug for scales.  Remote operator’s pendant complete with all start/stop and emergency stop push buttons;

 

Diesel Power: 215 Cont. HP rated @ 1800 RPM, electronic controlled governor,  emergency shutdown system for low oil pressure, overspeed and high temperature, one 125 gallon fuel tan, and two (2) 8D batteries.

 

Generator:  Lima MAC-R series, heavy-duty base mounted, 75 KW, 460 volts, 3-phase, 60 hertz.

 

Magnetic Separator: Dings Model 33CR continuous belt magnet with stainless steel clad discharge belt, 5 HP, 1800 RPM, TEFC, electric motor drive, magnet rectifier converts AC voltage to DC voltage.

 

Subject to prior sale: "AS IS, WHERE IS".

PRICE FOR ABOVE.....$110,000

<< Back to Used